Computer jacquard knitting machine to produce the wrong flowers, what is the reason squandering?

If you do not consider the special circumstances of particular organizations brought only consider the needle incorrect due to wrong flowers and squandering the case, there are the following possibilities:

a. poor knitting machine needle selection with the degree of synchronization itself, will lead to irregular squandering the entire disk, then re-adjust the parameters to the machine.

b. jacquard depth selector plate is not pressed, it will result in a lateral squandering. Jacquard middle pin is pressed into tablets linked, if the middle pin is depressed is not enough, the final intermediate needle still be quite straighten triangle knitting needle, appears certain large ones flowers confusion, squandering transversely.

c. Jacquard abnormal wear piece (jack or pins are similar phenomenon), will cause vertical squandering.

d. loom assembly design problems, resulting in an overall pattern confusion, this problem is relatively rare.

e. reset triangle or jack three track design or processing problems, resulting in particular large ones squandering. Problems in the case of being worn or fitted rear triangle design appears.

f. (position selector will jacquard sheet when pressed into the deepest barrel) relative to the needle selection jack triangle, the two are too close, leading to squandering. Middle pin needle selection is not completed action (being pushed jacquard pieces linked) has entered jack triangle track, leading to squandering, usually lateral squandering the entire disk.

g. selector and jacquard pieces assembled position with the heel of the poor, leading to squandering. For example selector at the head of this should not be pressed to lift jacquard piece, but because the low mounting position selector leads down to the jacquard piece, which appeared certain large ones squandering.